0

Allen Key to fit Slaters Wheels

Std hex key suitable for the replacement screws on the front of a Master Chassis if you have a deep chassis

Std hex key suitable for the Csk Axle holding screws on top of the Master Chassis

Std hex key suitable for the Slider locking screws front and back of the Master Chassis

A stand with a large base to help prevent spillages. You will receive a flat pack kit. The made up version in the photo is for reference only

Std small size 13/16 inch die holder fits all small BA dies complete with 3 screws to adj depth of cut with split dies

Double ended 2mm and 4mm round ball used to create curves in paper card and plasticard

Plastic storage tube with 2 PVC caps. Intended to store 1ft lengths of brass wire, & sections etc. Most of wire, tube & sections are 1ft long. We have now increased the length to 355mm which also makes them suitable for Evergreen plastic strips and sections. They can be easily cut down to what ever lg suit you

0

Tool used to pull the worms of a motor shaft. Comes with 2 screws to suit different shaft dia 1.5 & 2.0mm

Adjustable frame spacers to suit all kits in a paticular gauge. Supplied with 2 extra strong magnets. Used as an assembly aid in the construction of Locomotive chassis.

Very small double ended hammer head dia 8.5mm

Set of 6 plastic forming tools to make hand rails of 3 different widths in 2 different thicknesses of wire and 6 different depths

A tool for accurately holding thin metal parts (etches) and then folding precisely on the line required. It includes special cut-outs on 1 side for doing intricate 3 dimensional folds

A tool for accurately holding thin metal parts (etches) and then folding precisely on the line required. It includes special cut-outs on 1 side for doing intricate 3 dimensional folds

A tool for accurately holding thin metal parts (etches) and then folding precisely on the line required. It includes special cut-outs on 1 side for doing intricate 3 dimensional folds

A tool for accurately holding thin metal parts (etches) and then folding precisely on the line required. It includes special cut-outs on 1 side for doing intricate 3 dimensional folds

A tool for accurately holding thin metal parts (etches) and then folding precisely on the line required. It includes special cut-outs on 1 side for doing intricate 3 dimensional folds

Miniature wooden pegs pack of 10. Great for holding metal parts together while soldering as they don't melt, don't suck up heat, and the spring is quiet strong.

A clamping jig for holding small tubes sections or strips at either 90 45 or 60 deg Once clamped because the jig is made out very hard steel you can saw and file againt the jig to get a perfect joint

Slightly larger than the small it has 3 grooves plus a length gauge

Made of hardened Steel in 3 parts you can cut both 90 deg and 45 deg cuts in small sections of brass etc You can saw and file up against the jig to make very accurate and sharp joints ready for soldering

Punch and Anvil for the Metalsmith Rivet Tool. Suitable for rivet sizes expected in 4mm/ft models

Punch and Anvil for the Metalsmith Rivet Tool. Suitable for rivet sizes expected in 7mm/ft models

Master Tools